Traub TNX 65/42

Traub TNX 65/42 Milling and Turning Center

Mfd. 2007

Serial #7060107

Commissioned in 2010

TX 8i-S control (Mitsubishi/Traub based control with Mitsubishi drives and motors)

15 CNC axis’s

(4) X-Y-Z turrets with 10 positions each. Up to 20 tools per turret

65 mm thru hole main and sub spindle (sub spindle has coolant flush)

Foot pedal control for clamp/unclamp of spindle chucks

Servo driven gantry receiver

Hydraulic swivel w/ pneumatic finished part and bar remnant gripper

Finished part conveyor belt

RESY paper band coolant filter

Knoll Coolant tank with BKW refrigerated coolant temperature control

20 Bar High pressure and 8 Bar Low pressure coolant pumps

Knoll chip conveyor

FMB Turbo 5-55 magazine bar feeder (new in 2010)

2) Single stick turning tool holders

2) Double stick turning tool holders

1) Cut-off tool holder

1) Overdriven double radial live ER Collet tool holder

1) Overdriven radial live ER Collet tool holder

4) Radial live ER Collet tool holders

1) Radial live End Mill tool holder

1) Angle adjustable live ER Collet tool holder

2) Radial live Shell Mill tool holders

2) Axial live End Mill tool holders

6) Axial live ER Collet tool holders

43) Additional  tool holders on separate list (see supplemental attachment)

Hainbuch main spindle collet chuck

Rohm sub spindle 2 jaw chuck

2 Spare sets of spare Z-axis ball screws and bearing packs.

 

Tool holders (most brand new( the ones not pictured ), FMB Bar loader, refrigerated coolant/ band filter etc. are included. As well as new spare amplifier boards and a few ball screws and bearing packs.

 

Machine was stripped down to expose all inner workings and completely steam cleaned of all built up oil/chips.

Coolant tank/ filter and chiller as well as chip conveyor stripped down and completely steam cleaned.

Coolant filter float replaced.

Replaced any worn non functioning wires and hydraulic lines.

Replaced complete hydraulic system to include motor, pump and regulator.

Replaced main spindle hydraulic chuck automatic pressure regulator.

Replaced ball screws and bearing packs on X3 Y3 X4 (may be others that I don't recall)

Replaced any worn parts in each turrets live tool drives.

Replaced all rubber way wipers and brass wear parts on every sliding way covers.

Replaced all telescoping way covers on T1 T2 T3 T4

Refinished or replaced all slidable way covers.

New filters

New batteries

 

Model: 
TNX 65/42
Serial Number: 
7060107
Brand: 
Manufacture Date: 
2007
Condition: 
Used

Vertical Tabs



Machine Information Request

Have questions about this machine? Please complete the form below and a Graff-Pinkert representative will respond to your inquiry as soon as possible.

Graff-Pinkert | 4161 166th Street, Suite B, Oak Forest, Illinois, USA 60452
Tel. 1-708-535-2200 | Fax 1-708-535-0103
Copyright © 2024 by Graff-Pinkert & Co., Inc., and its licensors. All rights reserved.
Best Chicago Web Design by MediaNut